The company specializes in the production of air-cooled high-frequency electroplating power supply, electrolytic power supply, electroplating equipment, small electroplating experimental power supply, rectifier.Suitable for: electroplating, brush plating, electrolysis, oxidation, polishing, electrophoresis, electroetching and other industries that need rectifying electricity.Electroplating power supply is a direct current equipment which converts alternating current of power frequency into different voltages, frequencies and waveforms. "Rectification" technology is mainly applied in thyristor rectifier, and "inverter" technology is applied in high frequency switching power supply. Electroplating power supply mainly consists of main circuit and control circuit.
The porosity was reduced, and the nucleate formation rate was higher than the growth rate, which promoted the nucleate refinement.
Advanced technology, with imported "IGBT" module as the main power device, and ultra-fine crystal (nanocrystalline) soft magnetic material as the core of transformer.
High efficiency, 15%-30% power saving compared with SCR rectifier. It plays an important role in cost reduction of electroplating enterprises.
High precision, high stability and low ripple. The main control part adopts double closed-loop control technology to make the voltage fluctuation and load change of the power grid have no impact on the output.
the output voltage and current are adjustable, and can operate under the two states of stable voltage or steady current, and can adapt to different use occasions.
The structure design is beautiful and reasonable, the overall sealing effect is good, and it can operate in bad environment. Industrial electromechanical co. LTD
Complete protection functions, including voltage limit, current limit, over-voltage, over-current and over-heat protection functions. 556.1688.com
1.The altitude shall not exceed 3000 meters
2.The ambient temperature is from -15℃ to 40℃, and the air temperature is not more than 90%
3. There is no serious conductive dust around, and no flammable or explosive dangerous material medium.
4, no violent vibration and impact site.
5. The input power of the equipment shall be connected through an external air switch and grounded wirelessly.
6. The current output copper bar is located behind the panel. The section of the copper bar selected when connecting electricity from the plating tank shall not be less than the planting area of the bronze plate output by this machine.
7, before use, please choose a good way of work: such as stable voltage or steady flow, steady flow is generally used for automatic line continuous plating, fixed voltage applicable to hang plating or rolling plating.
8, the power switch start work indicator is on, the current, the value of the voltmeter are zero state, adjust the output adjustment knob on the power equipment, so that the output reaches the required value: voltage stability, power voltage change or negative change can keep the output voltage constant. When the current is steady, the change of supply voltage or load can keep the output current constant.